biochrom HB Ultrospec 7500, User Manual, Page: 101 / 104

Ultrospec 7500 User Manual • 41 56 2050 REV03 • 101
ACCESSORIES
Accessory Part Numbers
80-2108-01 8 Position Cell Changer
80-2106-01 4 Position Cell Holder
80-2106-07 10 – 50 mm Cell Holder
80-2107-14 100 mm Single Cell Holder
80-7100-71 Quantimate Micro Volume Cuvette 200 µl
80-7100-72 Quantimate Micro Volume Cuvette 500 µl
80-2140-62 Printer Accessory Ultrospec 7500
80-7100-33 Resolution CFR Software
80-2119-89 IQ/OQ Documentation for Ultrospec 7500
80-2119-90 PQ Documentation for Ultrospec 7500
Accessory Installation Guide
Instruction 1 – Multiple Position Cell Changers
Instruction 2 – Single Cell Holders
Instruction 1 – Multiple Position Cell Changers
1. Remove the 8 Position Cell Changer, supplied as standard, by grasping the outer carousel with one hand. Then loosen the central
finger screw with the other hand, until the cell changer comes free.
2. To install the new cell changer accessory, align the cell changer to the accessory motor by rotating the carousel until it falls into
place. Secure the cell changer by grasping the outer carousel with one hand, and then tighten the central finger screw with the
other hand until the cell changer is held tight.
Instruction 2 – Single Cell Holders
1. Remove the 8 Position Cell Changer, supplied as standard, by grasping the outer carousel with one hand. Then loosen the central
finger screw with the other hand, until the cell changer comes free.
2. Insert the blanking plug, supplied with the single cell holder accessory, over accessory motor position.
3. To install the single cell holder accessory, align the keyhole clips over the sample compartments accessory studs. Then slide the
keyhole clips to lock the cell holder in place.