Biocare iM 12, User Manual

Page: 144 / 196

Chapter 11 Other Functions
--132-- User Manual of Veterinary Monitor
Figure 11.2 Nurse Call Setup

Nurse Call
Set nurse call function: Off or On.

Signal Type
Set the type of output signal that triggers nurse calling system: Pulse Low or Hold Low.

Trigger Alarm Level
Set the alarm level that triggers nurse calling message: High, Mid, Low, you can choose multiple or none.

Trigger Type
Set the alarm type that triggers nurse calling message: Physiology alarm or Technology alarm, you can
choose multiple or none.
Attention

If you select neither [Trigger Alarm Level] or [Trigger Type], then no alarm will trigger nurse calling
signal.
Warning

Nurse call function cannot serve as the main alarm message source. You should combine the
audible and visual alarm of the equipment with animals
‟ clinical manifestations and symptoms, to
serve as the main alarm message source that notifies the doctors and nurses about an alarm state.
11.5 Defibrillation synchronization
When detecting R wave, the monitor will output a defib.Syn pulse signal. Defibrillator gets the defib.Syn signal
from the monitor and should discharge accordingly during the declining period of R wave to reduce damage to the
animal‘s heart.
Warning

Improper use of a defibrillator may cause injury to the animal. The user should determine whether to
perform defibrillation or not according to the animal
‟s condition.

Before defibrillation, the user must ensure both defibrillator and monitor has passed the system test
and can be safely used jointly.

Before defibrillation, make sure that [Defib. Sync] is set to [On] and the [Filter] is set to [Diagnostic].

After defibrillation is finished, disconnect the defibrillator.