Biocare iM 12, User Manual

Page: 152 / 196

Chapter 14 Maintenance
--140-- User Manual of Veterinary Monitor

Hospital Information
Input name of hospital and department name.

Units Setup
Select [Unit Setup>>] to open [Unit Setup] Menu, in which you can select the animal‘s height, weight,
monitor CO
2
pressure, blood pressure, CVP, temperature and ST voltage.
Height: cm, inch
Weight: kg, lb
CO
2
: mmHg, kPa, %
Blood Press: mmHg, kPa
CVP: mmHg, kPa, cmH
2
O
Temp:
℃
,
℉
ST Voltage: mV, mm
O
2
: mmHg, kPa, %
Show Unit: Disable, Enable. If you select ‗Enable‘, the parameters will be shown in the selected unit on the
parameter window of main screen. If you select ‗Disable‘, no parameters will be shown.

Time Setup
Refer to 3.9.4 for details.

Alarm Config
Refer to 7.6 for details.

Net Setup
By selecting [Net Setup>>], you may set the bed number, network mode (wired or wireless), local IP address,
server IP address and default gateway. After finishing the setting, select [Storage Settings] to confirm.

Defaults Manage
Refer to 3.10 for details.

Touch Screen Calibration
Select [Touch Screen Cal.], so that the cross icon ‗ + ‗ will be shown sequentially at different positions on the
screen. Click at the center point of ‗ + ‗ in sequence to make calibrations. After the calibration is finished, the
monitor will display the prompt: press [Retry] to calibrate again; Press [OK] to save the new touch screen
parameters and exit; Press [Cancel] to cancel the saving of new parameters and exit. The user may select as
needed.

Maintenance of CO
2
Module
Refer to 6.8.5 and 6.8.6 for details.

Other Setup
Notch Filter: 50Hz, 60Hz. It is used for setting the frequency of power frequency wave trap.
ECG Off Level: High, Mid and Low. The user may set the level of ECG lead off. The alarm prompt will
also display the corresponding alarm level.
SpO
2
Off Level: High, Mid and Low . The user may set the level of SpO
2
sensor fall. The alarm prompt will
also display the corresponding alarm level.
Tone Modulate: On or Off . Set if needed to modulate SpO
2
value to the pulse rate.
While DC: Fan On or Fan Off. It is used for choosing to stop the fan when the monitor is powered by the
battery.
Record Bold Curve: On or Off. If you select On, the wave curve on the log paper will be bold.
Curve Draw: by Ladder or Color Steps . It is used for setting the mapping method for the waveform on the
screen.
Wave Lines: Thin, Middle or Thick. It is used for selecting the coarseness of the waveform in vertical
direction on the screen.