BINDOMATIC 301 DFS, Operator'S Manual

Page: 66 / 84

60 Problem solving
Problem-solving table
The table below lists some conditions that may occur during
the operation of the 301 DFS. You can resolve the problems
without calling for service by following the suggested
solutions in the table. For problems with the host machine
beyond the scope of this table, refer to the operator manual for
the host machine. For problems with the 301 DFS beyond the
scope of this table, call for service.
Condition Causes Suggested solutions
Jam Clearance
Interface Module is not
accepting the copy sheets
from the host machine
reliably or the copy sheets
are jamming
as they enter the Interface
Module. The 301 DFS is not correctly
aligned with the host machine. Check the Alignment Marking
to ensure that it is in the
correct position and that the
301 DFS is correctly aligned
with the host machine.
Top sheets of copy sets
and loose sheets are
skewed, damaged or left
behind as they are fed
into the 301 DFS. Paper curl could be causing
the top sheets to catch on the
feeder rolls and/or the top
sheets that are left behind. Flip or replace the paper in
the paper trays of the host
machine.
Frequent misfeeds in the
4a area.
The covers may be stuck
together because the cover
cassette is damaged and/or the
covers have become deformed
due to improper storage. Clear the jam as directed in
the ”Locating and clearing a
jam” section of this chapter.
Check the cover cassette for
damage that may be causing
the covers to feed improperly.
Ensure that the cover
cassettes are being stored as
directed in chapter 5,
”Maintenance”.