Bilanciai FLYNET 100, Use, Maintenance And Installation Manual

Page: 60 / 125

58
FLYNET 100
signal must be activated.
Memory full Set the percentage at which the memory is
considered full.
Memory check time Allows setting the check interval.
Displays alarm
messages Enables the display of messages.
Inputs /
Outputs
Inputs 2 internal inputs and, if an optional board is installed inside the Flynet
indicator, it is possible to view the additional inputs available. It is
possible to choose to use the normally open or normally closed input.
Outputs 2 internal outputs and, if an optional board is installed inside the Flynet
indicator, it is possible to view the additional outputs available. It is
possible to choose to use the normally open or normally closed output.
Range
Select Range through the key to add a fully customizable
weight range.
Output number Shows a list of available outputs.
Define here which output will be activated.
Scale alias Shows the list of selectable scales.
Define here on which scale the range will be applied.
Lower
threshold Editable range expressed in the unit of measurement
selected by the system.
Enter a numerical value to define the minimum weight
threshold after which the selected output will be
activated.
Upper
Threshold Editable range expressed in the unit of measurement
selected by the system.
Enter a numerical value to define the maximum weight
threshold after which the selected output will be
deactivated.
Type of weight It is possible select the type of weight to activate the
output.
Net Weight or Gross Weight only.
Update time Indicates how often (ms) the weight is checked.
Disabling input It is possible to select an input to deactivate the range
operation.
Setpoint
Select Setpoint through the key to add a fully customizable
setpoint.
Output number Shows a list of available outputs.
Define here which output will be activated.
Scale alias Shows the list of selectable scales.
Define here on which scale the setpoint will be
applied.
Type of
threshold Indicates when to activate the output, i.e. if the
weight is:
•
Weight ≤ setpoint
•
Weight
< setpoint
•
Weight > setpoint