96
FLYNET 100
6.2.3
Pulse input analogue output board
To obtain the current output, place the jumper J14 on pins 2-3; the relevant output pins are 11
(output current), 9 (input current). The manageable current must be ≤ 190 mA (AC/DC).
To obtain the voltage output, place the jumper on pins 1-2; the relevant output pins are 12 (output
voltage), 8 (GND). The switchable voltage must be ≤ 24 V (AC/DC).
If an analogue output expansion board is installed inside the indicator, the connections must follow
these instructions:
Figure 6.2-7 - Analogue Output Board Connections (0-10v, 4-20mA)
A galvanically isolated analogue output is available on the connector in the 0-10 V and
0(4)-20 mA versions; the connection diagram is shown in the following table:
Analogue current output:
Place jumper J14 in position 2-3 for 4-20mA current output, between pins:
11 (Current Out) and 9 (Current In)
Analogue voltage output:
Place jumper J14 in position 1-2 for voltage output, between pins:
12 Voltage Out and Pin 8 (GND)
ATTENTION
Technical characteristics:
Resolution = 10000 points
Accuracy = 0.05 % FS
Minimum output voltage load = 100 ohm
Maximum current output load = 250 ohm
Summary of Contents for FLYNET 100
Page 2: ......
Page 112: ...110 FLYNET 100 ...
Page 121: ...119 FLYNET 100 10 12 Assembling disassembling the HDMI port ...
