101
FLYNET 100
Service
of
the
Service
Network
http://www.coopbilanciai.it/it/home/rete-vendita-e-
selecting your country
).
9.2
Version with cable glands
Figure 9.2-1 - Calibration button - Stainless steel indicator version
Key:
1. Indicator opening protection seal
2. Stamped self-adhesive label sealing the protective screw of the calibration switch
3. Calibration switch
Referring to the previous figure, proceed as follows:
•
Switch the indicator on.
•
Remove the seal (ref. 1), unscrew the four screws on the cover of the indicator and open it,
being careful not to detach the display connector.
•
Remove the self-adhesive label (ref. 2) which seals the access hole to the calibration switch.
•
Using a non-metal tool, press the calibration switch (ref. 3).
ATTENTION
Removing the metrological stamps makes it impossible to use the weighing indicator for
commercial transactions towards third parties. For their restoration contact the After Sales
Service
of
the
Service
Network
http://www.coopbilanciai.it/it/home/rete-vendita-e-
selecting your country
)
.
2
1
3
Summary of Contents for FLYNET 100
Page 2: ......
Page 112: ...110 FLYNET 100 ...
Page 121: ...119 FLYNET 100 10 12 Assembling disassembling the HDMI port ...
