Bilanciai DD1010, Use, Maintenance And Installation Manual

Page: 35 / 132

33
DD1010 FLYNET
5.2.1.1.1 Internal Scale
The internal scale is a Scale that uses the converter on board the indicator.
The type of scale is determined by the type of converter installed. When the internal scale is created,
the programme checks the type of converter.
Select the internal scale to display eight buttons (if indicator approved) or ten buttons (if not
approved). Access to sampling (sampling procedure) depends on the type of approval. Access to the
calibration key is only possible if the self-adhesive label that seals the calibration switch access hole
is removed.
To create an Internal Scale click the “ADD” key and select Internal Scale:
CHARACTERISTIC PARAMETERS
Minimum
weighing Compliance with the maximum tolerated error is only assured above this weight
setting.
Capacity This is the maximum weight value that can be loaded on the scale or full scale of
the instrument.
Division This is the scale resolution expressed in the selected unit of measurement.
Unit of
measurement kg, g, t, lb,oz and tn
Legal scale Indicates whether the scale is intended to be used for legal purposes (e.g.
commercial transactions) or not.
Regulations EURO, OIML, NTEP (indicates the selected standard)
SPECIFIC PARAMETERS
Reading time This is the reading time of the internal scale board, it is expressed in hundredths of
a second.
Conversion
speed It is active for both analogue and digital scale. In case of digital scale it refers to
the cell reading speed per second (number of readings/second).
Number of
cells This is the number of cells present in the system; this parameter is present only
when the cells are digital.
TARE
Tare Device Activated It is possible both to set the tare through acquisition of the weight
on the scale or by entering a tare value directly from the keyboard
Self-weighing
only It is only possible to set the tare through acquisition of the weight
on the scale; tare values may not be entered from the keyboard.
Preset only Tare values may be set from the keyboard only, not by acquisition
of the weight on the scale
Deactivated Tares may not be set either through acquisition of the weight on the
scale or by entering a tare value directly from the keypad.
Multiple
Tares No "No" indicates no additional tares.
1.2 Indicates the number of additional tares relative to the acquired tare
and the tare entered from the keypad.
Tare lock It defines the management mode of the tare when unloading the scale.