37 | Wi-Q™ Mercury Setup and User Guide
3 HARDWARE INSTALLATION
3 HARDWARE INSTALLATION
3.2.5.5.3 Sign On Wi-Q Controllers to the WQXM-PG
The enrollment process for the Wi-Q Controllers requires a default
token followed by a sign-on token and can take 20-30 seconds.
The sign-on is also confirmed with a three-tone increasing frequen-
cy beep1-beep2-beep3 and 3 flashes of the green LED on the lock.
If the sign-on fails there will be three beeps with decreasing tones
and 3 red LED’s.
NOTE:
If the controller is a WAC or Omnilock, there will not be
any audible beeps.
3.2.5.5.3.1 Keypad Method
• If a keypad is attached to the Wireless Door Controller
(WDC) do the following:
• Enter 5678# and then within 3 seconds enter the
6-digit sign-on key then the # key.
• Example: 5678# 816645#
• If there is a keypad on the Omnilock or Wireless Access
Controller (WAC) do the following:
• Enter 5678 and then within 3 seconds enter the 6-digit
sign-on key.
• Example: 5678 816645
• The Wi-Q Controller should sign on to the WQXM-PG and
display the controller’s unique MAC address at the bottom
of the STATUS page. (STATUS page not shown).
Credentials already in the system can be edited (or deleted) by
clicking the ‘Edit’ button on the Credentials home screen, and
saved once done.
Credentials can be deleted from the Credentials screen as well.
Choose the user to be removed, click the ‘Delete’ button.
Click ‘Confirm’ on the pop-up notification window when editing is
complete.
