BERNINA Stitch Regulator (BSR)
128
Changing the presser foot sole
NOTICE
The lens of the BSR presser foot is dirty.
The machine doesn't recognize the BSR presser foot.
> Clean the lens with a soft, slightly damp cloth.
The basic stitch length is 2 mm. When sewing small shapes and stippling it is recommended to shorten the
stitch length to 1 – 1.5 mm.
> Raise the needle.
> Raise the presser foot.
> Switch the machine off and disconnect it from the power supply system.
> Remove the presser foot (see page 41).
> Press both push buttons at the BSR foot against each other.
> Pull the presser foot sole out of the guide downwards.
> Insert the new presser foot sole into the guide and push upwards until it clicks into place.
> Attach the BSR presser foot (see page 127).
11.7 Securing
Securing in BSR1 mode with the button «Start/Stop»
Prerequisite:
• BSR presser foot is attached and connected with the machine.
• The BSR display is opened and the BSR1 mode is activated.
> Lower the feed dog.
> Lower the presser foot.
> Press the button «Needle up/down» twice.
– The bobbin thread is brought up.
> Hold the upper and the bobbin thread.
> Press the button «Start/Stop».
– Start the BSR mode.
> Sew 5 – 6 securing stitches.
> Press the button «Start/Stop».
– The BSR mode stops.
> Cut the thread.
Securing in BSR2 mode
Prerequisite:
• BSR presser foot is attached and connected with the machine.
• The BSR display is open and the BSR2 mode is activated.
> Lower the presser foot.
1017815.0.04_2016-05_Manual_B765_EN
Summary of Contents for 765 SE
Page 1: ...BERNINA 765 SPECIAL EDITION...
Page 200: ......
