26
Bentone
!
When servicing oil-bearing components, check for
oil leakage when the burner is commissioned after
servicing.
!
Before obtaining access to terminals,
all supply circuits must be disconnected.
J
K
6.4 Oil pump
1.
Switch off the main power supply and disconnect the Euro plugs from
the burner.
2.
Detach the oil hoses from the pump.
3.
Loosen screws (J) and pull out the oil pump.
4.
Measure the distance from the pump bracket to the pump connector
(K).
5.
Move the pump connector to the new pump and set the same
distance as before (K).
6.
Fit the oil pump to the burner and tighten the screws (J). (It is important
that the pump shaft splines align correctly in the pump connector).
7.
Fit the oil hoses.
8.
Refit the Euro plugs and switch on the main power supply.
9.
Bleed the pump, start the burner and set the correct oil pressure (see
Technical data for correct output).
10. Start burner and check/adjust combustion.
!
When servicing/replacing components that affect combustion,
flue gas analysis and soot test must be carried out following installation.
Summary of Contents for B 70i-3R FAME J
