Bentone B 70i-3R FAME J, Assembly, Installation And Maintenance Instructions

Page: 102 / 112

Err
or
code
Diagnostic
code
Meaning for the LMV37.4... system
Remedy
9
Manual locking by the PC software Communication breakdown
During a curve adjustment via the ACS410, communication between the LMV37.4... and the ACS410 was interrupted for more than 30 seconds
33
Manual locking after PC software reset attempt
PC software made a reset attempt although the system worked correctly
168
#
Internal error management
Make a reset; if error occurs repeatedly, replace the unit
169
#
Internal error management
Make a reset; if error occurs repeatedly, replace the unit
170
#
Internal error management
Make a reset; if error occurs repeatedly, replace the unit
171
#
Internal error management
Make a reset; if error occurs repeatedly, replace the unit
200 OFF
#
System error-free
No error
201 OFF UPr
#
Start prevention
Start prevention due to unparameterized unit Go to error history, entry 702, for initial cause of the error with shut
down in connection with the
first curve settings
Bit 0 Valency 1
No operating mode selected
Bit 1 Valency 2..3
No fuel train defined
Bit 2 Valency 4..7
No curves defined
Bit 3 Valency 8..15
Standardized speed undefined
Bit 4 Valency 16..31
Backup / restore was not possible
202
#
Internal error operating mode selection
Redefine the operating mode (parameter 201)
203
#
Internal error
Redefine the operating mode (parameter 201). Make a reset; if error occurs repeatedly, replace the unit
204
Phase number
Program stop
Program stop is active (no error)
205
#
Internal error
Make a reset; if error occurs repeatedly, replace the unit
206
0
Inadmissible combination of units (basic unit - AZL2...)
207
#
Version compatibility basic unit - AZL2...
0
Basic unit version too old
1
AZL2... version too old