Belden Grass Valley GV Korona, User Manual

Page: 253 / 433

253
Kayenne/Karrera/GV Korona
User Manual
that router source, changing that source’s output signal. If an exact match is not found for
the name entered, no change will occur.
Protection
The Router Protection pane (middle) provides protection controls. These controls are used
to send commands to the external router to protect or un-protect the router destination
associated with the selected switcher source. The button for the current setting of the
selected switcher source will be highlighted. The following protections are available:
• Protection Off – Source can be changed at any time by any control panel,
• Protection Off All Destinations – Same as Protection Off but for all destinations.
• Protection On – Source cannot be changed by another Control Panel, but may be
changed from the GV Switcher system,
• Protection On All Destinations – Same as Protection On but for all destinations.
• On Air Protection – The source cannot be changed by another control panel when it is
on-air, but may be changed manually from the GV Switcher system. The source will also
not be changed by an R-MEM recall, and
• On Air Protection All Destinations – Same as On Air Protection but for all destinations.
External router system panels can place protections on router destinations. The first panel
placing a protection controls that destination. The GV Switcher system will not be able to
change router sources feeding router destinations protected from another panel, and vice
versa.
Router Indexing
Starting with K-Frame software version 9.0, the GV Switcher system uses indexing to
manage router connections (instead of router names), therefore you can change router
source and destination names without affecting router source control.
Add Router Indexing to Shows Created with Earlier Versions
To add indexing to shows created on switcher systems with software earlier than 9.0, you
will need to load the show then create a new show with router indexing enabled.
1 In the File Ops, Show Files menu, load a show file created using an earlier version of
software.
a Navigate to and select the show using the System Storage or Remote Storage tabs
and navigation buttons in the Directory Search pane (left).
b Select Load Show in the Show Create & Load menu pane.
2 In the Eng Setup, Router menu, select Index in the Type menu pane.
3 In the File Ops, Show Files menu, select Create Show in the Show Create & Load menu
pane.
4 Name your show by selecting the Show Name data pad, entering the name in the pop-
up keyboard, and selecting Enter .
5 Select your preferences in the Create Show pane (right), and select Create .