Belden Grass Valley GV Korona, User Manual

Page: 183 / 433

183
Kayenne/Karrera/GV Korona
User Manual
mapped numerous times, and saved in Panel Memory (Local E-MEM Module/File Ops,
Panel Mem menu). Source selection buttons can be mapped as:
• Switcher sources—Can be delegated to source selection for any M/E bus, Aux
bus/Aux selection, Router control, Macros, or E-MEM recall,
• Shift function—There are four shift levels 1st (unshifted), 2nd, 3rd, and 4th,
• Row Delegation function—Mapped to the right-most source select button
(default). The SND (Source Name Display) associated with the row delegation
button indicates the name of the bus or function, e.g. K2, MACRO, Router, U2, etc.,
• SND LEDs— SNDs have two modes, ‘Full’ and ‘Split’. If both adjacent rows have identical
text for a source, it is displayed in full, i.e. large text. If the two rows have different text,
the SND is split into two rows of smaller text. SNDs show source names, macro names,
router source and router destination names, Aux bus numbers, etc.
• Shift buttons—Shifts can be mapped anywhere on the Source Select Module (or
nowhere) using the User Prefs, Button Mapping menu (default is 2nd and 3rd on the
second and third source select buttons from the right).
Function and Delegation Buttons
The following describes the function and delegation buttons:
• Hold button—Sets a bus hold on the delegated row.
• M/E bus select buttons— K1 - K6 , A , B , U1 , and U2 in columns 2-4, pressing one of these
buttons delegates that bus.
• Macro select button—Delegates rows 1 and 2 of a Source Select Module to macros.
• Key Split button—Creates a split key when a source is selected for the fill signal, the
Key Split button is held down, and a source is selected on a row delegated to the key
bus.
• Far button—The Far modifier is used for DPM rotation transitions. During DPM
operations, the side that is seen by the user is defined as the ‘near side’. To set the far
side for the current delegation of a bus, press and hold the Far button (and shift button
if necessary) and make a source selection for that side.
• Aux select button—Delegates Rows 1 and 2 of a Source Select Module to Aux bus
control.
• Router select button—Delegates Rows 1 and 2 of a Source Select Module to Router
selection.
• Rules Hold button—When pressed (toggle), Source Rules will not be applied to the
M/E delegated to that Source Select Module.
• E-MEM select button—Delegates rows 1 and 2 of a Source Select Module to E-MEMs.
Note: To delegate one row, hold down the Macro button and press a bus
delegation button or hold down the bus delegation row button and
press the Macro button.
Note: To delegate one row, hold down the E-MEM button and press a
bus delegation button or hold down the bus delegation row button and
press the E-MEM button.