Belarus 1523, Operating Manual

Page: 278 / 312

BELARUS- 1523/1523В /1523.3 /1523В.3 Scheduled Maintenance
267
Procedure 46. Changing Oil in the
Transmission Housing
1. Run the tractor and warm up oil in the
transmission.
2. Remove the filler neck plug (2) located
on the on the right side of the clutch
housing.
3. Screw out the drain plugs (1) of the
transmission and the plugs (3) of the
axle-shaft housings.
4. Discharge oil from the transmission
into a special vessel for collection and
storage of waste oils.
5. Refit the drain plugs back in place and
fill in fresh oil up to the mark “ П”
(“Full”) against the oil -level indicator
(refer to Procedure. 3). Refit the plug
(2).
6. Run the tractor for 5...10 minutes and
check the oil level. Add oil to the level,
if necessary.
Procedure 47. Changing Oil in the
HPS Oil Tank
At the working temperature of oil in the
oil tank, proceed as follows:
• screw out the filler neck plug (2);
• screw out the plug (3) and discharge
the oil into a special vessel prepared
beforehand;
•
screw in the plug (3), fill in fresh oil up
to the mark “С” against the oil-level in-
dicator (1); place the plug (2) back in
place.