Beckhoff AMP8000, Operating Instructions Manual

Page: 75 / 109

Mechanical installation
Version: 1.1
───
75 AMP8000 and AMP8500
► On all relevant modules, slide the bar for the AX bridge [1] to the
right
The contacts can then no longer be seen.
► Screw the screws back into the mounting plate of the machine or
plant as shown in the drilling pattern
► Place the coupling module [1] at the right side of the coupling
module [2] onto the screw [3] and carefully press against the
mounting plate [4]
1
2
► Once again, guide the screws [1] through the rectangular cut-
outs in the module housing [2]
► Make sure that the plates of the rear panel of Module [1] are not
overlapping and that the modules are sitting flush in cut-out [2]
► Bay further modules and screw all remaining screws tight on the
module housings
► Observe tightening torques:
Components Tightening torque [Nm]
Screws M5 x 5
Strength class 8.8 6