If a travel path is set, the drive command will not be immedi-
ately ended when the respective limit position is reached.
The corresponding relay remains switched on for an addi-
tional 60 seconds in order to ensure that the actual limit pos-
ition is reached.
Deleting the travel path
When the travel path is deleted, the set intermediate posi-
tions and the tilt will be deleted as well.
Select the required receiver as described in the
chapter Selection of the receiver for the setting
mode [
Open/close the shading solution to a point
between the limit positions.
3s
First press the programming button and, within 1
second, press the STOP button at the same time
and hold both buttons down for 3 seconds.
▻
The receiver confirms.
▻
The transmitter confirms with red
pulsing of the LED ring.
►
The reference route is now deleted.
3s
Then press the programming button for 3 seconds
to change to normal mode.
►
The LED ring goes out.
24 - en
