Becker CentronicPLUS VC520 PLUS, Assembly And Operating Instructions Manual

Page: 23 / 52

Setting the travel path
Intermediate positions can only be fed back and pro-
grammed once the travel path has been set. A time of
between 1 second and 10 minutes can be set as the travel
path.
The set drive limit positions are not affected by changes to
the programming of the travel path.
Select the required receiver as described in the
chapter Selection of the receiver for the setting
mode [
}
19].
Close to the lower limit position.
3s
First press the programming button and, within 1
second, press the
button at the same time and
hold both buttons down for 3 seconds.
▻ The receiver confirms.
▻
The transmitter confirms by lighting up
the lower third of the LED ring green.
Then close to the upper limit position.
3s
First press the programming button and, within 1
second, press the
button at the same time and
hold both buttons down for 3 seconds.
▻
The receiver confirms.
▻ The transmitter confirms by lighting up
the upper third of the LED ring.
3s
Then press the programming button for 3 seconds
to change to normal mode.
► The LED ring goes out.
►
The reference route is set.
23 - en