Bayer HealthCare ADVIA 60, Operator'S Manual

Page: 17 / 128

2. INSTALLATION
Page 2/7 075D0002-01
This message appears when the instrument is setup with the manual startup cycle to prevent any
analysis cycle before running a startup cycle. Press any key, the main menu is displayed:
MAIN MENU 1 RESULTS
HH : MM 2 QC
2.11. REAGENT PRIMING
When the ADVIA 60-
CT
is first installed, it contains no reagents. All the reagents have to be
primed now. Turn ON instrument by pressing the ON/OFF switch located on the rear panel. When
the instrument turns on, the display shows:
STARTUP NOT INITIATED
PRESS A KEY TO CONTINUE...
PLEASE WAIT FOR 3 MIN
ESCAPE : ESC
This time is required at the startup for the instrument initialization and stabilization, specifically
for the HGB diode to reach its operationnal temperature. After three minutes, the LED of the front
panel turns from red to green and the display shows the following:
2.10.1. Connection
Diag.2.12
The printer is connected to ADVIA 60-
CT
with the
cable delivered with the instrument. Lock the
connector in place by tightening the 2 screws on each
end of the connector to the
ADVIA 60-
CT
. Attach the
other end of the cable to the printer and lock the printer
connector in place by the means of the 2 clips located
on the connector itself.
NOTE:
On the ADVIA 60-
CT
, it is necessary to select the printer format RESERVED 1 of the
"PRINTER" menu (function 4) accessible through the "OPTIONS" menu (function 5 of
the main menu) then "RESULTS" (function 1).