Bay Networks NauticaRS, Reference Manual

Page: 289 / 608

Working with Paths
117237-E Rev.00 7-61
Frame Relay Paths
The attributes for a frame relay (RFC1490) are set in a similar
way to those for Ethernet, PPP and Nautica connections. To create
a new frame relay path, use the following Syntax:
[co] [new] pa frr/name
Where co takes the router into config mode (if required), new is
the new verb (Appendix A), pa moves you into the path object,
frr (frame relay router) is the path type ( page 7-5 ) and name is
the user defined name for the path.
To edit an existing frame relay path, use the same syntax as
above, but replace the new verb with the mod verb. mod is the
MTD for the modify verb (Appendix A). For example:
[co] [mod] pa frr/wat1
To remove an existing frame relay path from the unit, use the
same syntax, but replace the verb with the del verb. del is the
MTD for the delete verb (Appendix A). For example:
[co] del pa frr/wat1
When you edit or create a frame relay path, the BCC moves you
into the frame relay path object. Typing i at this prompt lists all
the attributes for the object.
Note: frame relay paths are usually auto-learned by the router.