Bay Networks 6300, Supplement Manual

Page: 81 / 593

A-53
Chapter 3 Configuring the PRI Interface, Global Ports,
Remote Annex 6300 Supplement to the Remote Annex Administrator’s Guide for UNIX
Book A
Table A-4. Parameters for the set pri Command
(continued on next page)
Parameter Description
switch_type A string specifying the type of switch provided by the
telephone company for your PRI line. Valid values
are:
AT9 (for the AT&T 5ESS switch)
DMS (for Nortel’s DMS100 switch)
NI2 (for a switch supporting National ISDN2)
ETS (for Euro ISDN, NET5 conformance)
The default is
""
, a blank string. The RA 6300
interprets this as a switch type appropriate for the
line:
With a T1 line, AT9 is used.
With an E1 line, ETS is used.
The switch type parameter is not case-sensitive.
dsx1_line_length The approximate distance, in meters, from the RA
6300 PRI interface to the external CSU. Enter this as
a range, e.g., 0–25 (the default), as a single number,
e.g., 30, or as a unique part of a range, e.g., 136–. If
you enter a single number, the
RA 6300 picks the range that the number falls into.
(You can then use the pri show command to
determine the range assigned.) Valid ranges are
0–25, 26–65, 66–100, 136–185, 166–185, and
186–210.
fdl_type The type of Facilities Data Link supported by the
telephone company for your PRI line. Valid values
are att and ansi. This parameter is applicable only to
internal CSUs used with T1/PRI lines. To display
statistics for an internal CSU, see Displaying
RA 6300 Statistics on page B-41.