Operation manual for
BAUER RAINSTAR
Series T32, T42
15
2 If you use a FORKLIFT to unload the RAINSTAR from the truck, proceed as follows:
2.1.
Forklift hoisting position in the middle of the reel. Lower the machine in horizontal position.
2.2.
Put down the machine on three wooden blocks, one below the drawbar and two below the frame at the
axle positions. Ensure that the assembly is firmly support !
2.3.
Pull out the turntable lock bolt and turn the reel 180 degrees.
2.4.
Secure the turntable again with the lock bolt to prevent swivel motion. The drawbar is opposite the cart
now.
2.5.
Insert the axles in the chassis frame. Adjust track width as needed. The threaded hole for the indication
bolt must point towards the setting slot. (See point 1.3).
2.6.
Secure the axles with the bolts. (See points 1.4.-1.5.)
2.7.
Mount the jack (see point 1.6).
2.8.
Lift up the RAINSTAR with the forklift on the rear (on the cart side) and remove the wooden blocks below
the axles.
2.9. Lift up the drawbar with the jack or with the forklift and remove the wooden block
underneath the drawbar
3.
Mounting the drawbar coupling ring
Mount the coupling ring depending on the tractor’s coupling height. In coupled position the RAINSTAR should be
standing about horizontal.
Note:
Tighten the bolts with 210 Nm!
4.
Remove the locking bracket from the reel
5.
Remove the tape from the gear shift lever.
The gear shift lever remains in the same position.
6.
Remove the locking bracket from the cart lifting frame
