Operation manual for
BAUER RAINSTAR
Series T32, T42
31
PRE-IRRIGATION:
Pressing the key
PRE-
can activate pre-irrigation. The time for pre-irrigation is calculated by the
ECOSTAR 4300
as 8 x the time for running 1 meter with the current speed.
The constant „8“ (constant no. 2) can be changed, see programming. If the pre-irrigation is on the machine starts
and runs 1/2 pm enter and then it stops for the pre-irrigation time. By pressing the key
„START“
the pre-irrigation
is cancelled. The magnet at the stop sensor should be in place, before activating the pre-irrigation.
POST-IRRIGATION
:
The post-irrigation can be activated by pressing the key
„POST-“
. The time for post-irrigation is calculated by the
ECOSTAR 4300
as 8 x the time for running 1 meter the current speed. The constant „8“ (constant no.3) can be
changed, see programming. The post-irrigation starts to count down when the magnet is removed from the stop
sensor. When the magnet is removed, the motor for speed regulation stops the turbine. After the post-irrigation
time the shut-off valve closes ( or opens, is available, the valve low pressure) At machines with only one motor for
speed regulation the turbine starts after the post-irrigation. By pressing the key
„START“
the post irrigation is
cancelled. The magnet at the stop sensor should be in place before activating the post-irrigation. If the constant
no.8 “early stop” is selected, this function is activated. The machine shuts down if the distance is reached.
7.3
PROGRAMMING OF 4 DIFFERENT SPEEDS
Display must show menu 5.
The pipe should be pulled out before programming, so the computer can calculate the distance of the field to be
irrigated.
In the following example the length of the field to be irrigated is 400 m.
Press the
„PROG“-Key
3 x. The display shows.
400m 30.0m/h 0m
0m 30.0m/h 0m
0m 30.0m/h 0m
0m 30.0m/h 0m
The desired speed can now be set, here 25,0 m/h. Then press the
„PROG“
-key 1 x. The display shows:
400m 25.0m/h 0m
0m 30.0m/h 0m
0m 30.0m/h 0m
0m 30.0m/h 0m
The desired distance can now be set, here 300 m. Then press the
„PROG“
-key 1 x. The display shows:
400m 25.0m/h 300m
300m 30.0m/h 0m
0m 30.0m/h 0m
0m 30.0m/h 0m
Now the first zone is programmed and the procedure is continued for all 4 zones.
Zone 4 automatically ends at 000m.
When zone 4 is programmed press again the
„PROG“
-key. The display shows:
DLETE MENU PRESS
SAVE PROG PRESS
By pressing the key “
PROG“
- the program is saved and the irrigation is carried out according to the program. By
pressing the key
„MENU“
-the program is deleted and the speed stays the same for the whole field.
