3. Loosen the (2) set screws that hold the Needle Bar Driver Pin in place.
4. Remove the Needle Bar Driver Pin and Needle Bar Driver.
5. Replace the Needle Bar Driver.
Make sure the following is checked when reassembling the Needle Bar
Driver Assembly
•
Make sure the Return Spring is inserted into the Needle Bar Driver correctly.
•
The Needle Bar Driver Pin should be rotated so the bottom set screw aligns with the
flat spot on the Needle Bar Driver Pin.
•
The Pin should be pushed against the bottom of the Needle Bar Driver so there is no
play, however the Needle Bar Driver must rotate freely and spring back with the
return spring.
•
Lubricate the Pin and Driver lightly from the top before reinstalling them.
6. reinstall the Needle Bar Driver Assembly back into the sewing head. Then follow the
instructions for Adjusting the Needle Bar Depth
3
- 1
2
Troubleshooting
BE
V
T Series
Mechanical
Guide
Summary of Contents for BEVT Series
