Barudan BEVT Series, Instruction Manual

Page: 158 / 193

1. Place the circular felt pad on the thread stand before placing the new thread cone on
the thread stand.
2. Pull the thread from the cone through the back of the eyelet on the thread stand that is
directly above the cone.
3. Take the thread through the top eyelet of the first tensioner then to the right of the
tensioner between the silver discs and through the bottom eyelet of the tensioner.
4. Take the thread to the right of the second tensioner and let it sit into the cutout between
the two silver disks.
5. Take the thread over the white nylon disk from the right, go around 1time.
6. Pull the thread to the right of the tensioner assembly and wrap it one and one-half
times between the silve wheels and over the take-up spring.
NOTE: To ensure proper threading, pull the thread down, and check that
the take-up spring bounces up and down with the thread movement.
7. Thread through the top thread guide.
8. Thread through the next guide.
9. Thread through the third guide.
10. Pass the thread to the right of the take up lever, then through the next thread guide
from back to front.
11. Thread the eyelet in the take-up lever from right to left.
12. Thread through the next thread guide.
13. Thread through the next thread guide.
14. Thread the small pigtail that circles the needle, immediately below
the apron. Either pass the thread through from the top, or pass it
through the small opening on the right side of the pigtail
15. Thread the eye of the needle from front to back then through the large hole in the
presser foot.
BE
V
T Series
Mechanical
Guide Machine Basics
1
-
8