Adjusting the Needle Depth
Note: Follow the instructions for checking the needle depth first before following these
instructions.
1. Remove the middle thread guide and the front cover of the sewing head.
Note: The middle thread guide holds the front cover in place.
2. Loosen the (2) adjusting screws for the Needle Bar Driver Fixing Base, see photo.
3. Adjust the Needle Bar Fixing Base up or down accordingly to achieve the proper
needle depth. Tighten the adjusting screws when the proper depth is set.
Proper Needle Depth
•
½ the eye of the needle should be visible in the hook basket when the main pulley is
set to 0 degrees.
•
When using the Optional Needle Depth Gauge, the tip of the needle should barely
touch the top of the gauge when the main pulley is set to 24 degrees.
Note: If the needle depth cannot be set correctly, the needle bar driver
needs to be removed and inspected. If the Needle Bar Driver is cracked or
bent, proper needle depth may not be possible to set. See Needle Bar Driver
Replacement
Caution: Anytime the needle bar driver is cracked or bent, it needs to be
discarded and replaced.
3
- 1
0
Troubleshooting
BE
V
T Series
Mechanical
Guide
Summary of Contents for BEVT Series
