Barudan BENS, Operation Manual

Page: 23 / 103

apparent, push the lever down then return it to the on position. If this
occurs again, consult your technician.
2.
Press the green ON softkey on the automat. You will hear the fan in the
driver box, and in a few moments, the LCD display will come on. The
machine beeps loudly indicating it was powered on.
3. Press D, below the Execute icon, to allow the machine to seek its
origin.
NOTE: To bypass seeking the machine
origin, press A, and hold it down for about
five seconds, until the Origin Set screen
disappears.
NOTE: If the BENS shut off because of a
power failure while it was sewing, and the
needle remained in the fabric, you will
need to execute one of the manual
functions, such as a thread trim, to raise
the needle before moving the pantograph,
to avoid damage to the machine.
Once the origin is set, a blank LCD screen
displays.
Powering Off
1. Press the red OFF softkey on the automat.
2. When the machine will not be used for a long period of time, it is best
to turn off the power at the driver box. The green lamp above the
switch will no longer be lighted. This precaution will prevent the
machine from powering on, even if the ON key on the automat is
pressed.
CAUTION! Although the BENS is built to withstand electrical surges, it
is best to switch the power off during electrical storms, making sure to
switch the breaker off on the driver box, and unplug the machine. You
may also want to do this when the machine is shut down at the end of the
day.
1-18 Overview BENS Operation Guide - 12/99