To decrease cutting height:
Remove a lower adjusting collar and
insert it above.
1
s8skgg-002
Adjustment With Adjusting Collars_002
1
s8skgg-003
Adjustment With Adjusting Collars_003
1
Adjusting collar
After adjusting the adjusting collars at the
three locations, firmly tighten all nuts.
1
s8skgg-001
Adjustment With Adjusting Collars_004
1
Nut
Adjustment With Cutting Height Adjusting Plates
Cutting height adjusting plates are installed at
three locations on each mower deck.
Important
The length of grass cut off at any one time
must be no more than 30.0 mm (1.18 in).
[2]
5.
Important
Do not cut off more than 1/3 of the grass
height.
Apply the parking brake, and then lower all
mower decks.
Stop the engine, and then remove the key.
Loosen the six bolts securing the cutting
height adjusting plates at the three
locations on the mower deck.
1
2
3
1wwy8g-001
Adjustment With Cutting Height Adjusting Plates_001
1
Bolt
2
mower deck
3
Cutting height adjusting plate
Refer to the Cutting Height Table, and then
change the hole positions.
To increase cutting height:
While lifting the handle at each location
on the mower deck, remove the two
bolts.
Raise the mower deck to change the
hole positions, and then temporarily
secure it with the two bolts.
To decrease cutting height:
While lifting the handle at each location
on the mower deck, remove the two
bolts.
1.
2.
3.
4.
[1]
a.
b.
[2]
a.
GM2810A
Handling Instructions
Page 5-18
Adjustment before Work