Baroness GM2810A, Owner'S Operating Manual, Page: 71 / 155

Manual Regeneration
Danger Danger
Since it will become extremely hot around the
exhaust outlet during DPF regeneration, do
not perform the regeneration in a location
where fires may occur.
Important
When the system enters the level where DPF
regeneration is required, perform the
regeneration immediately.
Interrupting the regeneration or ignoring the
warning and continuing traveling or cutting
work may cause the engine and DPF to
malfunction.
Important
Manual regeneration can not be performed as
long as the DPF auto regeneration inhibit
switch set to the "Auto regeneration inhibit
mode".
Set it to the "Auto regeneration mode" to
perform regeneration.
Manual regeneration is the DPF
regeneration performed only by the expert
with the fault diagnostic tool. Normal
automatic regeneration or parked
regeneration can not complete regeneration
since large amount of PM accumulates.
Manual regeneration can be activated in any
PM accumulation level.
You can not continue to use this machine
for traveling and cutting work during DPF
regeneration.
You can not perform the regeneration.
(The fault diagnostic tool is required.)
Manual regeneration is activated in PM
accumulation "Level 4".
Manual regeneration is activated in any
PM accumulation level when the following
condition met.
when replacing DPF
when replacing ECU
￭
･
･
･
･
1.
2.
■
In PM accumulation "Level 4":
Important
If ignoring the manual regeneration
requirement and continuing traveling or cutting
work in PM accumulation "Level 4", PM
accumulation level enters "Level 5".
If still continuing traveling or cutting work, fatal
trouble will occur on the engine and DPF.
These are the statuses in PM
accumulation "Level 4".
"Excessive PM4" appears in the monitor
display.
Pressing an arrow key changes the
display to "CORRECTIVE ACTION:
Stop engine!! Contact dealer
immediately".
The LED (yellow) lights up.
The engine output is limited at 50%.
1 of 2
<
NEXT
>
HIDE
FMI 16
E x c e s s i v e P M 4
SPN 3701
C : 1
1 of 2
<
NEXT
> HIDE
FMI 16
C O R R E C T I V E A C T I O N :
S t o p e n g i n e ! ! C o n t a c t
d e a l e r i m m e d i a t e l y
SPN 3701
C : 1
1
1
2
2
27gtuu-005
Manual Regeneration_001
1 LED (yellow)
2 Arrow key
Stop traveling and cutting work.
Park this machine in a safe location.
Apply the parking brake.
Stop the engine.
1.
･
･
･
2.
3.
4.
5.
Description of Functions
GM2810A
Description of Functions
Page 4-35
Engine