These are the statuses in PM
accumulation "Level 3".
1
1
1 of 2
<
NEXT
>
HIDE
FMI 15
E x c e s s i v e P M 3
SPN 3701
C : 1
1 of 2
<
NEXT
>
HIDE
FMI 15
C O R R E C T I V E A C T I O N :
S t a r t D P F P a r k e d
R e g e n e r a t i o n
i m m e d i a t e l y
SPN 3701
C : 1
2
2
27gtuu-006
Level 3_001
1
LED (yellow)
2
Arrow key
"Excessive PM3" appears in the monitor
display.
Pressing an arrow key changes the
display to "CORRECTIVE ACTION:
Start DPF Parked Regeneration
immediately".
The LED (yellow) lights up.
The engine output is limited at 50%.
Stop traveling and cutting work.
Park this machine in a safe location.
Apply the parking brake.
Set the throttle opening to 0% (idling).
If the DPF auto regeneration inhibit switch
set to the "Auto regeneration inhibit
mode," set it to the "Auto regeneration
mode."
Press the DPF parked regeneration
switch.
Parked regeneration starts and the
regeneration icon changes from blinking to
lighting.
1.
･
･
･
2.
3.
4.
5.
6.
7.
When the regeneration completed, the
regeneration icon disappears.
Level 4
Danger
Danger
Since it will become extremely hot around the
exhaust outlet during DPF regeneration, do
not perform the regeneration in a location
where fires may occur.
Important
When the system enters the level where DPF
regeneration is required, perform the
regeneration immediately.
Interrupting the regeneration or ignoring the
warning and continuing traveling or cutting
work may cause the engine and DPF to
malfunction.
Important
If ignoring the manual regeneration
requirement and continuing traveling or cutting
work in PM accumulation "Level 4", PM
accumulation level enters "Level 5".
If still continuing traveling or cutting work, fatal
trouble will occur on the engine and DPF.
You can not continue to use this machine
for traveling and cutting work during DPF
regeneration.
You can not perform the regeneration.
(The fault diagnostic tool is required.)
8.
￭
･
･
Description of Functions
GM2810A
Description of Functions
Page 4-41
Engine