Baroness FS900, Service Manual, Page: 94 / 163

If it is not, tighten the nuts securing the
battery until it is firmly secured.
If the battery is not firmly secured by the
mounting bracket, the battery could move
due to vibration while the machine is
moving, resulting in damage to the battery
case or electrolyte leaks.
Inspection of the cable terminals for
looseness
If a connection between a battery terminal
and machine-side cable terminal is loose,
tighten the nut securing the cable terminal
until it is firmly secured.
Loose connections could result in an
insufficiently charged battery, damaged
terminals, or explosion.
Note:
If a terminal has corroded, polish it using a
wire brush or fine sandpaper, and apply a
small amount of anti-rust grease.
Inspection of the electrolyte level and
addition of distilled water
Important
When adding distilled water, be careful not to
add an excessive amount.
Check the electrolyte level by looking from
the side of the battery.
If the electrolyte level has fallen to less than
halfway between the
“
UPPER
”
(maximum
level line) and
“
LOWER
”
(minimum level
line) limits, add distilled water to the battery
immediately until the
“
UPPER
”
limit is
reached.
When adding distilled water, loosen and
remove the vent plug and add distilled
water up to the
“
UPPER
”
(maximum level
line) limit.
After adding distilled water, firmly tighten
the vent plug.
U P P E R L E V E L
L O W E R L E V E L
1
2
48yhlu-006
Inspection of the battery_001
4.
5.
1 Upper limit
2 Lower limit
Replacement of Battery
When replacing the battery, note the following
precautions and be sure to turn off the power
switch etc., stop the engine, and remove the
key before replacement.
Danger Danger
Do not replace the battery near open flames
or in a poorly ventilated area. Keep the battery
away from lit cigarettes and other open
flames.
Failure to observe these precautions could
cause a fire or explosion.
Do not short-circuit the battery.
If the positive and negative terminals are
connected to each other by a metallic tool, the
battery will short-circuit. And a short-circuit will
also result if the positive terminal contacts
another metallic part (machine body etc.).
When connecting a machine-side cable
terminal to a battery terminal, ensure that the
nut is firmly tightened.
A loose nut could cause a fire or explosion.
Warning
When connecting the machine-side cable
terminals to the battery, ensure that they are
correctly connected to the positive and
negative terminals.
Secure the battery firmly with the mounting
bracket.
Failure to do so could cause damage to the
battery, leakage of the electrolyte, fire or
explosion.
Do not modify the battery terminals.
Ensure that the vent plug or vent hole on the
side of the battery is not covered by the
connection cables etc.
Do not connect any electrical devices directly
to the battery.
FS900
Electrical system
Page 5-20
General inspection and repair