Barco XDL-4K75, User Manual

Page: 87 / 117

9. GUI – System Settings
9.3.2 Projector address
About individual projector address
Before a projector, and only this projector, can be controlled via a remote control, an individual address must be entered in the
projector.
This individual projector address can then be used to control the projector via remote control.
Next to an individual projector address, each projector has also a broadcast address for group control.
How to change
1. In the main menu, select System Settings → Communication → IR Control .
Image 9-9
Communication menu, IR control
The IR control menu is displayed.
Image 9-10
IR control menu
2. Select the current projector address and enter a new address.
3. Select APPLY and click OK to apply the changes.
From now on the projector will only listen to this new address and to its broadcast address.
9.3.3 IR sensors
What can be done?
Each IR sensor can be individually disabled or enabled.
When all sensors are turned off, the projector will no longer respond to signals from the remote control. To re-enable the sensors,
use the menu keypad on the projector.
How to disable
1. In the main menu, select System Settings → Communication → IR Control .
Image 9-11
Communication menu, IR control
R5906151 XDL 17/04/2018 83