Barco TransForm SCN, User Manual, Page: 52 / 61

6. Advanced configuration
Barco – TransForm SCN – R5976968 – Revision 01 – May 2006
________________________________________________________________________________________________
6-3
6.2 Resetting factory settings
To reset the T
RANS
F
ORM
SCN to factory settings the following procedure can be used.
•
Disconnect the T
RANS
F
ORM
SCN from the power supply; please refer to section 3.2.1 Power supply .
On the right side face of the T
RANS
F
ORM
SCN there is a small hole with the reset button [19] in it.
19
Figure 6-1
T
RANS
F
ORM
SCN – side view, front panel is shown on the left, back panel is shown on the right
•
Push the reset button. Use a lean, non-metallic object for this purpose.
•
Keep the reset button pressed while you reconnect the T
RANS
F
ORM
SCN to the power supply.
•
Stop pressing the reset button
•
Wait until all the LEDs light up
•
Wait till the T
RANS
F
ORM
SCN is back to operating state
•
Disconnect the T
RANS
F
ORM
SCN once again from the power supply and reconnect it.