3. Getting started
Barco – TransForm SCN – R5976968 – Revision 01 – May 2006
________________________________________________________________________________________________
3-2
3.1
Examining
3.1.1
TransForm SCN
The front:
5 6 7 8
10
9
1
12
12
2 3 4
1
red LED 1:
temperature
on – temperature error
2
green LED 2:
DDC Hot Plug detect
on – display is connected and generates hot plug signal
off – display is not connected or display does not support hot plug signal
3
green LED 3:
signal detection
on – analog or digital Sync detected
off – no Sync detected
4
green LED 4:
Ethernet activity
blinking – Ethernet activity
5
red LED 5:
Fan
on – fan error
on, LED 1 and LED 5 blinking – internal error
6
green LED 6:
software heartbeat
blinking – OK, otherwise there is an internal firmware error
7
green LED 7:
input type
on – analog input
off
–
digital
input
8
green LED 8:
power
on – power OK
9
DVI in
10
DVI out
11
USB (for keyboard and mouse connection)
12
ventilation slots
Figure 3-1
front view of TransForm SCN
On the front panel of TransForm SCN there are eight
LEDs
[1-8], indicating the operating state of the device. On
the left side there is a
DVI in
connector [9] and a
DVI out
connector [10] to insert and loop through the source
signal. On the right side there is a
USB
connector [11] for remote operation of the screen content.