Barco TransForm SCN, User Manual, Page: 23 / 61

3. Getting started
Barco – TransForm SCN – R5976968 – Revision 01 – May 2006
________________________________________________________________________________________________
3-7
3.3 Starting up
3.3.1 Connecting
•
Connect T
RANS
F
ORM
SCN to the local area network by connecting the network adapter! Please, refer to section
3.2.3 Network !
•
If desired, connect a monitor to the DVI out connector of the T
RANS
F
ORM
SCN, please refer to section 3.2.2
Graphical data .
•
Connect the T
RANS
F
ORM
SCN to the power net; please, refer to section 3.2.1 Power supply !
•
Connect the graphic source to T
RANS
F
ORM
SCN; please refer to section 3.2.2 Graphical data .
•
If you want to remotely control the host PC, connect the T
RANS
F
ORM
SCN and the computer who generates the
graphical source with the provided USB cable; please refer to sections 3.2.4 Remote Pointer !
3.3.2 Switching on
Initial system start after delivery
The T
RANS
F
ORM
SCN is preconfigured at the factory with a default IP address. Therefore before con-
necting the T
RANS
F
ORM
SCN to your company’s network, its network settings have to be adapted.
For the configuration of the network properties please refer to 6.1 Initial configuration of the network
settings .
When power is applied to the T
RANS
F
ORM
SCN the green LED power OK [17] on its back is lighting and the device
is automatically switched on and initializes. When initialization is ready, the green LED software heartbeat [6]
starts blinking and the device is in operation mode.
The device is controlled via the T
RANS
F
ORM
SCN web interface; please refer to section 4.3 TransForm SCN web
interface .
If the host PC does not support DDC, then the output timing of the host PC has to be checked. It may not exceed
a resolution of UXGA (1600×1200), which is the maximal T
RANS
F
ORM
SCN input resolution. Please refer also to
section 4.1.2 DDC and 7.1 Technical data .
3.3.3 Switching off
To switch off the T
RANS
F
ORM
SCN simply the power supply has to be disconnected.
If TransForm SCN is switched off the graphical signal is also no longer looped through.
Therefore after switching off the TransForm SCN you should connect the monitor directly to
the host PC, to be able to see the graphical output!