Barco TransForm SCN, User Manual, Page: 36 / 61

4. Operating
Barco – TransForm SCN – R5976968 – Revision 01 – May 2006
_______________________________________________________________________________________________
4-13
4.3.7 Encoder settings – timing
On the Encoder Timing page the timing settings of the applied signal are indicated.
The encoder is able to auto detect all VESA timings, therefore for VESA timings it is best to have auto-detection
enabled. For all other signal timings auto-detection should be disabled and the settings should be indicated in
the respective fields.
Timing
Auto Detection
Enabled VESA timings can be auto detected. The detected timing is indicated
on the Status screen; please see
4.3.8 Encoder settings – status below.
Timings supported by auto detection are listed in section 7.1 Technical
data
Disabled For non-VESA timings the timing settings have to be entered manu-
ally; five additional textboxes are displayed and have to be filled in.
Horizontal Resolution
Horizontal resolution of graphics output of the host PC
Vertical Resolution
Vertical resolution of graphics output of the host PC
Horizontal Total
resolution:
640×480
800×600
1024×768
1280×1024
1400×1050
1600×1200
Select the following values for the known resolutions. For non-VESA timings the
values are only meant as an initial start value, which must be adapted unless the
image is correctly adjusted:
refresh rate:
60 Hz 75 Hz 85 Hz
values: 800 840 832
1056 1056 1048
1344 1312 1376
1688 1688 1728
1864 1896 1912
2160 2160 2160
Horizontal Phase
Use 40 as a start value and adjust this value until the left border of the output fits
Vertical Phase
Use 5 as a start value and adjust this value until the top border of the output fits
Sampling Phase
In case that picture jittering occurs the sampling phase can be adjusted.
Only applicable for analog sources!