Manual # 26-0208100-00 / Revision E
ScreenSHAPER – Video Mapping System 35
Command:
ORAS n
Description:
Puts a white raster box on the output display if Rotation is at 0 degree. If Rotation is at 90, 180 or
270, the output raster box can not be enabled.
Note: If the display area is not full screen, the edge area will be white when Output Raster Box is
Enabled.
Parameters:
n
-
[0|1] Disable|Enable
Query:
ORAS ?
Returns the output raster box mode:
=n
Example: ORAS 1
(Select to put a white raster box on the output display).
Command:
OSYNC n
Description:
Adjusts the Output Sync.
Parameters:
n
-
Sync mode; [0|1|2|3|4|5], SOG|-C|+H+V|+H-V|-H+V|-H-V
Query:
OSYNC ?
Returns the Output Sync mode in the format:
=n
Example:
OSYNC 3
(Adjusts the Output Sync value to be +H-V.)
Command:
PAR n
Description:
Set the parity type for serial command port.
Parameters:
n
[0|1|2] NONE|ODD|EVEN
Query:
PAR ?
Returns the parity type
=n
Example:
PAR 1
(Set ODD parity)
Command:
RESET
op
Description:
Resets all system variables or reset the system to factory defaults
Parameters:
op
-
Reset operation; [A|F], All|Factory
Example:
RESET A
(Resets all system variables.)
Command:
ROT n
Description:
Rotate image. This command is only recognized in the ROTATE Operation Mode.
Parameters:
n
[0|90|180|270]
Query:
ROT ?
Returns the current rotation setting
=n
Example: ROT
90
(Rotate the image 90 degree.)
Command:
SAVE
Description:
Saves the system parameters to non-volatile RAM. Upon power up, the system
parameters stored in non-volatile RAM are used for system configuration.
Parameters: None
Example:
SAVE
(System parameters are saved to non-volatile RAM.
