22
ScreenSHAPER – Video Mapping System
Manual # 26-0208100-00 / Revision E
System Setup Menu
The System Setup Menu allows the user to control input frame synchronization, change the configuration of the serial
port, provides information for access to factory technical support and allows the system to be completely reset to
factory default values. This menu is displayed by pressing the
SYS SETUP
key on the front panel.values.
Save Settings
This menu selection is used to save changes made in the System Setup menu to non-volatile memory. If this menu
item is not selected, changes will not be saved and the previous settings will be restored the next time the system is
powered on.
Serial Port Submenu
The ScreenSHAPER has one serial port that is configured for RS-232 operation. The serial port parameters are
under this submenu. Configuration parameters entered in this menu are saved in non-volatile memory if you issue a
SAVE SETTINGS command under the System Setup Menu.
Echo
The user can turn ECHO ON or OFF. When ECHO is ON, commands received by the unit will be transmitted back to
the source device. The default setting is ON.
Baud Rate
The following baud rate settings are supported 1200, 2400, 9600, 19.2K, and 38.4K. The default baud rate setting is
38.4 Kb.
Data Bits
The number of data bits per character can be set to 7 or 8. The default setting is 8.
SYSTEM SETUP
SAVE SETTINGS ^
SERIAL PORT
>>
F/W VERSIONS >>
TECH SUPPORT >>
DIAGNOSTICS >>
VFD BRIGHTNESS 8
OPERATION MODE WARP
SYSTEM RESET >>
SERIAL MODE RS-232
ECHO ON
BAUD RATE 38.4K
DATA BITS 8
STOP BITS 1
PARITY NONE
HANDSHAKING ON
RESET RS-232
^
