18
ScreenSHAPER – Video Mapping System
Manual # 26-0208100-00 / Revision E
Display Area Submenu
The following four configuration controls, available when operating in the Rotation Mode, are used to set an output
display area. The default settings define a full-screen based on the selected output resolution. These settings can
be changed to define a particular rectangle within the active output frame.
Figure 3-3 Display Area Definition
Left Edge
Left Edge is used to set the output display area. This control adjusts the left edge by changing the width of the blank
area on the left. See Figure 3-3 for detail. The default setting is 0.
Right Edge
Right Edge is used to set the output display area. This control adjusts the position of the right edge. See Figure 3-3
for detail. The default setting is 1280.
Top Edge
Top Edge is used to set the output display area. This control adjusts the top edge by changing the width of the blank
area on the top. See Figure 3-3 for detail. The default setting is 0.
Bottom Edge
Bottom Edge is used to set the output display area. This control adjusts the position of the bottom edge. See Figure
3-3 for detail. The default setting is 1024.
DISPLAY AREA
LEFT EDGE 0
RIGHT EDGE 1280
TOP EDGE 0
BOTTOM EDGE 1024
