Barco ImagePRO-II Jr, User Manual Addendum, Page: 112 / 166

ImagePRO-II • User’s Guide 97
4. Menu Orientation
Using a Logo or Internal Black
This section discusses both methods of capturing, deleting, and restoring a logo or internal
black.
In addition to these methods, you can also downloading or restore a logo from a USB flash
drive or from the ImagePRO-II Web Interface. For details, refer to
Using a USB Device on
page 88 of this chapter, or Backing Up and Restoring Data with the Web Interface , on
page 132 of Chapter 5.
Please note the following important points regarding the logo:
•
After you save a logo, the image remains in memory across power cycles.
•
You can de-select the logo on display by pressing one of the input buttons or
BLACK .
•
When the LOGO or BLACK button is selected, the PAN/ZOOM button is not
operational.
•
When you power up an ImagePRO-II that has a stored logo, the LOGO button is
dimmed.
•
When the ImagePRO-II has no stored logo, the output displays black during
transitions.
•
You can overwrite a stored logo by capturing a new image.
•
If you perform a factory reset, the logo is cleared from memory and cannot be
retrieved.
•
When an HDCP-capable source is selected (inputs 1, 3, or 4 ), you cannot save a
logo image from that source.
•
With the 3D/Dual Channel mezzanine installed and the system mode set to
Dual2K, you can save and restore a logo to either channel. For more information,
refer to “
Backing Up a Logo in Dual-Channel Mode ” and “ Restoring a Saved
Logo in Dual-Channel Mode” on page 111.
^Äçìí=íÜÉ=ildl=_ìííçå
The LOGO button states are:
•
When selected, the LOGO button is lit .
•
If the ImagePRO-II has a stored logo, the LOGO button is backlit when you
power up the system.
•
When there is no stored logo, the LOGO button is not lit when you power up.
`~éíìêáåÖ=~=içÖç=rëáåÖ=íÜÉ=ildl=_ìííçå

To capture a logo using the LOGO button, use the following procedure:
1. Press and hold an input button.
2. Press LOGO .
The system captures the frame from the selected input, and stores the frame in
non-volatile memory. While the capture is in progress:
~
A progress bar and related messages are shown on the display screen.
~
The input button is backlit, and the LOGO button is lit.
aÉíÉÅíáåÖ=~åÇ=`~éíìêáåÖ=~=içÖç=rëáåÖ=íÜÉ=içÖç=jÉåì
The Logo Menu , shown in the following illustration, enables you to capture the source for
LOGO