88
ImagePRO-II • User’s Guide
4. Menu Orientation
Using the System Menu
•
MinDelay
. In this mode, the output format is automatically mapped to the input
format and locked for minimal delay. This mode is useful when you want to
convert a 3G Level B input to a 3G Level A output or vice versa.
•
Quad to Dual.
This mode combines the input from two ImagePRO-II units to drive
a 4K projector. For more information about the Quad to Dual mode, refer to
Operating the ImagePRO-II in Quad to Dual Mode
rëáåÖ=~=rp_=aÉîáÅÉ
The front panel of the ImagePRO-II contains a USB port that you can use to connect a flash
drive to the ImagePRO-II.
The following illustration shows the
USB Backup/Restore Submenu
, which you access
from the
System Menu
.
Figure 4-75.
USB Submenu
Using this menu, you can:
•
Detect the presence of a USB device.
•
Back up and restore ImagePRO-II configuration files. When you connect a flash
drive to the ImagePRO-II, the ImagePRO-II creates a directory titled
ImagePRO2Backup
on the drive. All logo images and configuration files are
saved to this directory.
•
Back up and restore a logo image. With the 3D/Dual Channel mezzanine installed
and the system mode set to Dual2K, you can back up and restore the logo
assigned to either channel.
_~ÅâáåÖ=ré=`çåÑáÖìê~íáçå=cáäÉë
To back up a configuration file to a flash drive, use the following procedure:
1.
Insert a formatted flash drive in the ImagePRO-II’s front-panel USB port.
2.
From the
System Menu
, scroll to the
USB Backup/Restore Submenu
. Select
Backup Config
.
The
USB Backup Config Submenu
appears, as shown in the following
illustration. The navigation cursor appears at the default name for the first backup
file.
Note
The flash drive must be formatted to use the FAT32 file
system. For formatting instructions, refer to
Formatting the
Flash Drive
on page 208 of Appendix C.
USB BACKUP/RESTORE
> USB Detected
No
Backup Config
>>
Restore Config
>>
Backup Logo
>>
Restore Logo
>>