ImagePRO-II • User’s Guide
107
4. Menu Orientation
Operating the ImagePRO-II in Dual-Channel Mode
Figure 4-97.
Status Menu in Dual-Channel Mode
Other menus — such as the
Output Timing Adjust
,
Area of Interest
,
Input Sizing
Adjust
, and
Zoom/Pan
menus — now provide the ability to select a channel before
adjusting parameters. You can create separate output settings on each channel for the
following parameters and functions:
•
Area of Interest
•
Output timing adjustments
•
Comp/S-video adjustments
•
Output effects, including contrast, brightness, gamma and color balance
•
Test patterns
You can also back up and restore logos on a per-channel basis.
Other settings, such as sync polarity settings and the colorspace/bit depth/sample rate,
apply to specific connectors. They are not assigned on a per-channel basis.
^Äçìí=fåéìí=pÉííáåÖë=áå=aì~äJ`Ü~ååÉä=jçÇÉ
You can create separate input settings on each channel for the following parameters and
functions:
•
Aspect ratio
•
Masks
•
Pan and zoom settings
•
Input sizing adjustments
All other input settings — including input timing, sampling mode, colorspace, color
adjustments, and deinterlace settings — apply to specific input connectors. They are not
assigned on a per-channel basis.
j~ééáåÖ=~å=lìíéìí=íç=~=`Ü~ååÉä
In dual-channel mode, you first map an output to one of the two channels, then adjust input
and output settings on Channel
A
, Channel
B
, or both channels at the same time.
To map an output to a channel, use the following procedure:
1.
Select
System
>
System Mode
>
Dual2K
.
2.
On the
System Menu
, select
Out Connector Map
. The
Out Connector Map
Submenu
appears, as shown in the following illustration.
IN:
1024x768 @59.94
Genlock: N/A
RGB
CHA:
1280x720p @60
CHB:
1280x720p @60