112
ImagePRO-II • User’s Guide
4. Menu Orientation
Operating the ImagePRO-II in Dual-Channel Mode
Figure 4-107.
USB Backup Logo Submenu in Dual-Channel Mode
3.
Either accept the default channel or change this selection and press
SEL
.
4.
Scroll to the next line, which displays the default name for this logo. If you wish to
change the name, press
SEL
. Use the
ADJUST
knob to change the name, as
described in
on page 75. Press
SEL
again when you
complete the name change.
5.
Scroll to
Backup Logo
and press
SEL
.
A message confirms the success of the backup operation.
oÉëíçêáåÖ=~=p~îÉÇ=içÖç=áå=aì~äJ`Ü~ååÉä=jçÇÉ
To restore a logo stored on a flash drive and assign it to a specific channel, use the
following procedure in dual-channel mode:
1.
Insert the flash drive in the ImagePRO-II’s front-panel USB port.
2.
From the
System Menu
, select the
USB Backup/Restore Submenu
.
3.
Select
Restore Logo
. The
USB Restore Logo Submenu
appears, as shown in
the following illustration.
Figure 4-108.
USB Restore Logo Submenu
4.
Select the channel to which you wish to restore the logo. The logo will become
available on that channel.
5.
On the next line, scroll through the list of stored logos. When you locate the file
you want, press
SEL
again.
6.
Scroll to
Restore Logo
and press
SEL
.
A message confirms the success of the restore operation, and instructs you to
reboot the ImagePRO-II.
USB BACKUP LOGO
> Channel
A
LogoBackupCHA_1
Backup Logo
USB RESTORE LOGO
> Channel
A
Logo1
Restore Logo
Note
You must reboot the ImagePRO-II to use the restored logo.