Barco iD PRO R600+, Owner'S Manual

Page: 70 / 179

6. Advanced
Image 6-57
if one uses a gray scale pattern, the bright spots should appear in the black bar.
Performing White input balance
1. Select a black pattern (or gray scale as alternative)
2. Press MENU to activate the Toolbar
3. Press → to select the
Image
item
4. Press ↓ to Pull down the
Image
menu
5. Use ↑ or ↓ to select
Input balance
6. Press → to pull down the menu
7. Use ↓ or ↑ to select
White balance
(image 6-58)
8. Adjust the red white level (gain) on a minimal value (image 6-59)
9. Adjust the blue white level (gain) on a minimal value
Note: this minimal value is not necessary , provided that the 2 other colors are not influencing too much the color to be adjusted,
in fact the aim is to minimize the effect of the two other colors since there is a risk of reaching too soon the transition
(bright spots) due to the contribution of these two other colors signals.
10.Adjust the Green white level (gain) until bright spots appear on the white part of the image
11.Adjust the Blue white level (gain) until bright spots appear on the white part of the image
12.Adjust the Red white level (gain) until bright spots appear on the white part of the image
The projected image should now be noisy neutral grey.
Image 6-58
64 R5976874 ID PRO R600/R600+ 21/09/2006