Barco iD PRO R600+, Owner'S Manual

Page: 53 / 179

6. Advanced
Note that native resolution refers here to the source and does thus only have sense when handling data sources (greyed out for
video sources).
Depending on the type of projector the “show native resolution” function will handle the sources as follows:
Source Projected image
Name Ratio Resolution Ratio Resolution Display
xga
4:3 1024x768 4:3 1024x768 image ceside blanked
sxga
5:4 1280x1024 5:4 1280x1024 image ceside blanked
sxga+
4:3 1400x1050 4:3 1400x1050 image centered
uxga
4:3 1600x1200 4:3 1600x1200 scroll image
Table 6-1
Show native resolution = ON
The
Full screen representation
function on the other hand forces to use the complete native resolution of the
LCD panels.
How to enable the “Show native resolution” function?
1. Press MENU to activate the Tool bar
2. Press → to select the
Image
item
3. Press ↓ to Pull down the
Image
menu
4. Use ↑ or ↓ to select
Show native resolution
(image 6-28)
5. Press → to pull down the menu
6. Use ↓ or ↑ to select
On
7. Press ENTER
A white bullet shows the selection
Image 6-28
The default mode is used if the
Show native resolution
and the
Full screen representation
are off.
The default mode shows always the native ratio and forces the native resolution of the panels (part of the
image blanked where needed)
When show native resolution is ON and the resolution of the source is higher than the panel resolution , use
the arrow keys to scroll through the image (pan).
R5976874 ID PRO R600/R600+ 21/09/2006 47