Barco Galaxy NW R9040406, User Manual

Page: 33 / 209

2. Installation
See the Display setup menu (for the stereo output and system settings) and the Image menu (for the stereo
input settings)
2.7.7 Active In fi tec
TM
The Active In fi tec TM feature is optional: a software key is needed to activate it.
How to connect when using active In fi tec TM stereo ?
1. The input connection is done in the same way as described above but the stereo output signal is not required in this case since
In fi tec TM stereo glasses are required instead (these glasses are passive i.e. not switched).
2.7.8 Network connection
What can be done ?
The projector can be connected to a network allowing it to be accessed from any connected network device. The Ethernet connection
can be used to upload/download projector software and/or to set up communication (TCP-packets) with the projector. This network
can be a local area network or a small dedicated network
Following operations are made possible :
• fi le transfer for fi rmware upgrade
• easy adjustment of projector
• storage of multiple projector con fi gurations and set ups.
• wide range of control possibilities.
• linking the projectors to allow uniform color (Linked Dynacolor) and brightness (CLO) ,...
• ...
The connection to the projector can be done via a crossed cable or via a HUB on the local network (LAN).
The Ethernet connection is also used to allow the Desktop integration. The software on the delivered CDROM
must therefore be installed on the desktop PC. See the Desktop integration software User Guide.
Connecting the projector to a network
1. Connect the RJ 45 male plug to the projector’s RJ 45 female connector
DVI DVI DVI DVI 1 2
DESKTOP INPUT DESKTOP INPUT
IN1 IN1 IN2 IN2
L1 L1
STEREO INPUT STEREO INPUT STEREO OUTPUT STEREO OUTPUT
L2 L2 L3 L3
IN1 IN1 IN2 IN2 IN1 IN1 IN2 IN2
RS 232 C RS 232 C DVI DVI R.C. R.C.
Image 2-29
Network connection (RJ45)
See Network settings to set the communication port.
R59770718 GALAXY NW SERIES 20/06/2013 27