Barco Galaxy NW R9040406, User Manual

Page: 193 / 209

7. Trouble shooting
7. TROUBLE SHOOTING
Overview
• Error codes
• Trouble shooting through the OSD
• Basic troubleshooting guide
7.1 Error codes
7.1.1 Introduction
Error display
The LCD module is located at the front side of the projector underneath the input module. It will display error codes in case a problem
is encountered.
Galaxy NW-12 standby
P11 Power Fail
Image 7-1
LCD Display : error display
Syntax of the error codes
The error code exists out of a pre fi x, two digits and a short message. E.g.
P11 Power Fail
. Possible pre fi xes are:
• T: temperature error
• F: fan error
• L: lamp error
• P: power error
• H: hardware error
If ever you have to contact Barco’s Helpdesk concerning an error code, make sure to mention the pre fi x and
both digits, since this data is most useful for Barco engineers to determine which actions have to be taken.
7.1.2 Overview of the error codes
Temperature errors
Description Location Pre fi x Code Message
Air pressure PB T 10 PB overtemp
Microcontroller PB T 11 PB overtemp
PFC heat sink PB T 12 PB overtemp
Ambient PB T 15 PB overtemp
Air pressure XFAN T 20 XFAN overtemp
Microcontroller XFAN T 21 XFAN overtemp
SMPS heat sink XFAN T 22 XFAN overtemp
Ambient XFAN T 25 XFAN overtemp
Lamp overtemperature or open LPS door Control engine T 50 Lamp overtemp
DMD overtemperature Controle engine T 51 DMD overtemp
Fan errors
Description Location Pre fi x Code Message
fan top LPS PB F 10 LPS top fan error
R59770718 GALAXY NW SERIES 20/06/2013 187