Barco F70 Series, User Manual

Page: 80 / 218

601–426 /15 F70 Series 80
The WOL is performed by sending a Magic Packet followed by the projectors MAC address. The MAC
address is found in the
Menu / Settings / Communication / LAN. menu. The MAC address is similar to the HW
address that is shown in this menu path.
The LAN cable must be connected when the projector enter the ECO mode, in order to obtain the
Wake on LAN function.
5.5 Power modes
General
The table below details the projector power modes.
Mode
Description
Normal Projector is booted up and the light source is on
Ready Projector is booted up but the light source is off
ECO Standby Light source is switched off and projector electronics
are powered down
5.6 Customize projector settings
About
The projector display, behavior and user interface can be adjusted to meet individual requirements.
Options include: Menu/Settings/Themes
• Adjust the OSD menu color
5.7 User interface
5.7.1 On Screen Display (OSD)
About
The projector on screen display (OSD) is the primary user interface (UI). From here, you can review and
adjust all projector and display settings.
The OSD interface uses tabs to display the main menu. Topics are then further sorted and displayed by
function: main (topic) — sub (function) — sub (function).
There are seven main menu tabs: Source, Image, Installation, Profiles, Settings, Test pattern and Status.
The OSD can be disabled by pressing the OSD on/off button.
In order to show the OSD, the OSD On/Off button must be disabled. (White backlight on the button).
When the button have blue illumination, the OSD will not appear, and the display information are
only visible on the LCD Display. Only Critical warnings will be displayed.
User access levels
The projector’s software platform uses access levels to define what each user can do.
There are two user access levels: Standard User and Power User. In addition, there is a Service user access
for certified Service personnel.
Getting started