Barco ClickShare, Installation Manual

Page: 24 / 53

4. Installing ClickShare
4.3 Wall mounted
Wall mounted
You can use the mounting brackets included in the ClickShare box to mount the Base Unit to the wall.
The total weight of the Base Unit — including the mounting brackets — is 2,9 kg.
Necessary tools
• a drill (type of drill depends on the type of wall)
• Torx T10 screwdriver
• Additional screwdriver that matches the mounting screws
Necessary parts
• 2 mounting screws
• 2 plugs
• Mounting brackets (included in the ClickShare box)
To install the Base Unit to the wall
1. Drill two holes in the wall, at a distance of 173 mm (6.81 inch) from each other.
2. Tighten 2 screws in the holes using the plugs.
Note: Mounting screws are not included in the ClickShare box at purchase. The type of screws needed depends on the type
of wall (stone, wood, plasterboard, ...) you are mounting the Base Unit to.
3. Install the Base Unit on the brackets making use of the mechanical fi xture points at the bottom of the Base Unit.
Note: For this purpose you can use the pre-mounted Pan Head T10 M3 screws (refer to image 4-2). Remove them from the
Base Unit and reuse them to
fi xate the brackets to the Base Unit.
14 R5900004 CLICKSHARE 21/08/2012