Barco ClickShare, Installation Manual

Page: 28 / 53

4. Installing ClickShare
Image 4-5
3. Secure the mounting brackets to the Base Unit using the four T10 screws.
4. Mount the Base Unit to the ceiling with the four mounting screws.
Tip: This procedure should be performed by two people: one person holding the Base Unit in place, one person tightening
the screws.
4.6 Connecting
C
AUTION
:
Make sure the Base Unit is installed properly before connecting.
To connect the Base Unit before use
1. Plug the power cable in the mains power connector at the back of the Base Unit
Refer to “1” on the fi gure below.
Note: The local variant of the power cable is included in the ClickShare box at purchase.
2. Connect the Base Unit to the display using a display cable.
Refer to “2” on the fi gure below.
Note: A display cable is not included in the ClickShare box at purchase.
Supported types of displays are:
-
Single Link DVI
- DisplayPort
- VGA: use the adapter included in the ClickShare box
- HDMI: use an adapter cable (not included in the box)
3. If you want to change settings on the web interface during installation, insert a network cable in the LAN port.
Refer to “3” on the fi gure below.
4. To power on the Base Unit, set the rocker switch to “I”.
Refer to “4” on the fi gure below.
18 R5900004 CLICKSHARE 21/08/2012